Comparative Study on the Transmission Characteristics of CDC Suspension under Different Damping Modes and Excitation Amplitudes
DOI:
https://doi.org/10.54691/h5tja742Keywords:
CDC Suspension; Transfer Function; Four Poster; Sweep Excitation; Amplitude Nonlinearity.Abstract
At present, Continuous Damping Control (CDC) suspension has been increasingly adopted in passenger vehicles to balance ride comfort and handling stability. However, most existing studies focus on control algorithm design rather than quantifying how adjustable damping alters the vehicle's vertical vibration transmission behavior, especially under varying excitation amplitudes. This article takes a production vehicle equipped with CDC dampers as the research object, and conducts sine sweep excitation tests on a four-channel road simulation test bench. Acceleration signals at the axle head (input) and the shock absorber tower top (output) are measured simultaneously. The suspension transfer function is calculated under three damping modes (comfort, normal, sport) and three excitation amplitude levels. By analyzing the transfer characteristics, the difference in transmission characteristics among different damping modes can be quantitatively analyzed, and the amplitude-dependent nonlinearity of CDC suspension can be revealed. The conclusion of this study can provide a basis for CDC calibration optimization and NVH problem diagnosis of different vehicle models.
Downloads
References
[1] Lee, G. W., Hyun, M., Kang, D. O., et al. (2022). High-efficiency active suspension based on continuous damping control. International Journal of Automotive Technology, 23(1), 123–132. https://doi.org/10.1007/s12239-022-0012-0.
[2] Wu, L., Zhang, W. Z., Yuan, D. F., et al. (2024). Model predictive control of a semi-active vehicle-mounted vibration isolation platform. Sensors, 24(1), 243. https://doi.org/10.3390/s24010243.
[3] Wu, L., Zhang, W. Z., Yuan, D. F., et al. (2024). Model predictive control of a semi-active vehicle-mounted vibration isolation platform. Sensors, 24(1), 243. https://doi.org/10.3390/s24010243.
[4] Chen, X. M., Liu, F. Y., Deng, J. C., et al. (2024). Ride comfort improvement method for trucks based on cab semi-active mounting with CDC shock absorber. Noise and Vibration Control.
[5] Lin, C. B., Wang, Y., Xu, E. Y., et al. (2024). Research on improved ADD control strategy for semi-active suspension. Noise and Vibration Control.
[6] Li, J. W., Luo, J. N., Huang, Z. (2023). Research on semi-active suspension controller design considering CDC system time delay. Automotive Engineering.
[7] Klockiewicz, Z., & Laski, G. (2023). Comparison of vehicle suspension dynamic responses for simplified and advanced adjustable damper models with friction, hysteresis and actuation delay. Acta Mechanica et Automatica, 17(1), 42–51. https://doi.org/10.2478/ama-2023-0006.
[8] Wang, B., Zhao, R. Y. (2023). Comparative study on the transmission characteristics of air spring suspension and traditional suspension of a certain vehicle model. CATARC Automotive Test Center.
[9] Krauze, P. (2023). Identification of control-related signal path for semi-active vehicle suspension with magnetorheological dampers. Sensors, 23(13), 5770. https://doi.org/10.3390/s23135770.
Downloads
Published
Issue
Section
License
Copyright (c) 2026 Scientific Journal of Technology

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.






