Research Status of Perforation Parameter Optimization of Different Well Types at Home and Abroad

Ke Xu

doi:10.54691/q938bd76

Authors

Ke Xu

DOI:

https://doi.org/10.54691/q938bd76

Keywords:

Perforation Parameters; Vertical Well; Horizontal Well; Deviated Well.

Abstract

Perforation is a process that penetrates the casing and cement sheath to establish a production channel for oil and gas. Reasonable perforation parameter design is the key to removing contamination and releasing production capacity. Perforation technology can improve the connection between the oil and gas layer and the formation to the greatest extent, thereby significantly increasing the production efficiency of crude oil. Nowadays, perforation technology is widely used in oil and gas field development. Therefore, optimizing perforation parameters is of great significance for improving the production efficiency of oil reservoirs. This paper investigates the current research status of perforation parameter optimization by scholars, and sorts out the research on three types of wells: vertical wells, horizontal wells, and deviated wells respectively.

Downloads

Download data is not yet available.

References

[1] Muskat, Morris. "The Effect of Casing Perforations on Well Productivity." Trans. 151 (1943): 175–187.

[2] McDowell, James M., and Morris Muskat. "The Effect on Well Productivity of Formation Penetration Beyond Perforated Casing." J Pet Technol 2 (1950): 309–312.

[3] Muskat, Morris. "The Effect of Casing Perforations on Well Productivity." Trans. 151 (1943): 175–187.

[4] Tariq, S. M., Ichara, M. J., and L. Ayestaran. "Performance of Perforated Completions in the Presence of Anisotropy, Laminations, or Natural Fractures." SPE Prod Eng 4 (1989): 376–384.

[5] Karakas, Metin, and S. M. Tarlq. "Semianalytical Productivity Models for Perforated Completions." SPE Prod Eng 6 (1991): 73–82.

[6] Lang, Z.X, Zhang, L.H, Zhu, J.C, et al. Development of perforating engineering application software WPSYS-A [J]. Journal of Petroleum University (Natural Science Edition),1992,(06):42-48.

[7] Pan, Y.D, Tang, Y.L, Feng, Y.P, Productivity prediction and optimization design of perforating completion parameters [J]. Acta Petrolei Sinica,1991,(02):61-71.

[8] Xiong, Y.M, Huang, C, Liu, X.W, et al. Research on optimization design of perforation completion parameters in gas field [J]. Fault Block Oil & Gas Field,2012,19(06):813-816.

[9] Zhou, S.T, Hole density optimization analysis of perforated horizontal Wells [J]. Petroleum Drilling Techniques, 2007,(05):55-57.

[10] Wang, M.J, Lian,Z.H, Xing,J.B, et al. Optimization of productivity ratio of perforation completion in inclined and vertical Wells [J]. Drilling & Production Technology,2012,35(04):22-24+122-123.